DAC Limited 711 Series Guide de l'utilisateur télécharger pdf

12 Document No 552625 Iss. 6 June 2005 1

ELECTRICAL INSTALLATION

External Bell

All bells must be approved for connection to the telephone netwrk. They

are of the low frequency A.C. ~pe (15Hz-25Hz). D.C. versions must NOT

be used. Connect to terminals 2 and 4 of the tag block. Ensure that DIP

switch SW18 3 is set to '3 (ON)' enabling the internal bell capacitor if a

master socket is NOT used.

Call Restriction Timeout (used when 'CLEAR' key is not fitted)

If this facility is enabled (SW18 -1 set to 'OFF') then each call will be time

restricted to approximately 1 minute, in one of two ways, set by SW18 - 2.

1. Fixed - (SW18- 2 set to 'OFF') the 1 minute starts from the last press

(and release) of the 'PRESS TO CALL' key or the service required.

2. Auto - (SW18 - 2 set to 'ON') the 1 minute starts from the end the last

incoming tone or speech.

Line Terminal Mode Selections

Summary of mode selectable DIP switches:-

OFF - enableSW18-1 Timeout enable:

ON - disable (factory

setting)

OFF - fixed (factory setting)SW18-2 1 minute timeout selection:

ON - automatic

ON - enabledSW18-3 Internal Bell capacitor (disabled

when master socket is used)

OFF - disabled (factory

setting)

Loop Dial- A (factory

setting)

SW24-1 Loop Dial or DTMF Dial

DTMF- 1

APPROVED for connection to

telecommunication systems

specified in the instructions for

use subject to the conditions set

out in them

DAC Limited

Lomeshaye Business Village,

Turner Road. Nelson. BB9 7DR

Tel: +44(0) 1282 447000

Fax: +44 (0) 845 280 1915

DAC LIMITED

USER GUIDE

FOR RA711/1011, /1012 & /1013

VANDAL RESIST TELEPHONES

Part No: 552625

Issue 6

1 2 3 4 5 6 7

Résumé du contenu

Page 1 - USER GUIDE

12 Document No 552625 Iss. 6 June 2005 1ELECTRICA

Page 2 - CONTENTS

2 11CONTENTSThis guide is in two parts. The first part is provided for users of thisinstrument and the second part is for the sole use of your approv

Page 3

2 111. Press 'ON', immediately followed by 'STORE'.2. Press particular Autodial key to be programmed, 'S0', 'S1&

Page 4 - ELECTRICAL INSTALLATION

10 3ELECTRICAL INSTALLATIONElectrical ConnectionsThe cables are passed through relevant conduit and connected (in thecase of directly wired situation

Page 5 - INSTALLATION

4 9APPROVED FACILITIESThis apparatus has been approved for use of the following facilities:-1 Loudspeaking (no handset) hands-free operation.2. Vis

Page 6

8 5INSTALLATIONThe following information is provided for use by the approved installer ortelephone network supplier only. The RA711 telephone can be

Page 7 - OPERATION - RA711/1011

6 7OPERATION - RA711/1011To make a callDepress the 'PRESS TO CALL' key, dialling tone will NOT be heard.Dialling takes place automatically,

Plus de documents pour Téléphones DAC Limited 711 Series

Voir le document DAC Limited 711 Series Manuel d'utilisateur

DAC Limited 711 Series Manuel d'utilisateur (8 pages)

Voir le document DAC Limited 711 Series Manuel d'instructions

DAC Limited 711 Series Manuel d'instructions (33 pages)

Voir le document DAC Limited 711 Series Guide de l'utilisateur

DAC Limited 711 Series Guide de l'utilisateur (12 pages)

Voir le document DAC Limited 711 Series Fiche technique

DAC Limited 711 Series Fiche technique (82 pages)

Commentaires sur ces manuels

Pas de commentaire

DAC Limited 711 Series Guide de l'utilisateur

Naviguer en ligne ou télécharger Guide de l'utilisateur pour Téléphones DAC Limited 711 Series. DAC Limited 711 Series User guide Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Téléphones DAC Limited 711 Series

Commentaires sur ces manuels

Produits connexes et manuels pour Téléphones DAC Limited 711 Series